2. Installation
Customers with a VT tractor only need to
connect the baler to their isobus connector at the back of the tractor, switch
on the contact and drive.
Customers who do not have a isobus
tractor will work as before : They install the tractor harness (which commes
with the baler) into their tractor and connect the screen. To install this wire
harness, you need to find battery power, ground and a 12V after ignition
signal.
The break away connector is placed at the
rear of the tractor.
ليست هناك تعليقات:
إرسال تعليق